JKBMS Accessory Selection Guide: Choose the Right Display, Cable and Module for Your BMS
Estimated reading time: 3 minutes
Teilen
JKBMS accessories are not universal. Each display, cable and module only works with the protection board series, version and ports it was designed for. Before choosing accessories in the Find your BMS selector, please read each accessory's product page and the manual of your exact BMS model.
Step 1: Identify your exact BMS model and version
- B / BD series (for example JK-B2A24S20P, JK-BD6A24S10P)
- PD models (simplified version, for example JK-BD6A20S8PD). PD models have no GPS port.
- HC / HCRPB versions of B/BD boards
- PB / PBD series (inverter BMS, for example JK-PB2A16S20P)
Check the label on the board, the order SKU and the hardware version. The switch cable is included with the BMS as standard, so you do not need to order it separately.
Step 2: Choose a display
B/BD and PB displays use different protocols and are not interchangeable, even when the screen size is the same.
- B / BD (including PD): 4.3" LCD, 3.2" LCD, 2.0" LCD or the Battery Level Indicator.
- PB / PBD only: LCD-4.3-TTL-P or LCD-7.0-TTL-P. These TTL displays do not work with B/BD boards.
Screen size itself is not a compatibility limit, as long as the display supports your board model. ESS cabinet panels are cut for a 4.3" display by default; if you choose the 7.0" display, the panel opening must be enlarged by hand. See the Display Guide: B/BD vs. PB for details.
Step 3: Choose a PC connection cable
- B / BD (non-PD, with GPS port): USB-TTL cable, connected to the GPS port of the protection board.
- PD models: no GPS port, so the USB-TTL cable is not supported.
- PB / PBD: USB-RS485-RJ45 cable, connected to the RS485 port of the interface board.
The two PC cables cannot be swapped between series.
Step 4: Choose expansion modules (only for matching versions)
- P-LINK module: soft parallel expansion for B/BD HC and HCRPB versions. Not for PB series boards. See the P-LINK soft parallel guide.
- Parallel Module: a hard-parallel accessory, different from P-LINK. It only works on versions with a Parallel Module Interface.
- Alarm module: for versions with an alarm / buzzer port, such as HCRPB.
Port locations by version are explained in the B & BD Series Interface Guide and the Inverter BMS Interface Guide.
Step 5: Read the product page and manual before ordering
Open the accessory's product page to check the supported models, ports and cable length, then download the manual for your BMS from the Download Center on our homepage. Always check the wiring against the actual PCB markings before powering on.
Not sure which accessory fits? Send us your BMS model and hardware version via WhatsApp or service@jkbms-ess.com and we will help you confirm before you order.